Buyer guide · Updated October 2026

Leaking pipe under the sink: waste, trap or supply?

A puddle in the cupboard under the kitchen sink or bathroom basin is a common find. The good news is that the pipework there is usually easy to reach, and most leaks come from a handful of joints. The first job is working out whether the water is coming from the waste, which only leaks while water drains, or the supply, which leaks all the time. This guide explains how to trace it and what each kind of leaking pipe joint usually needs.

Key takeaways

  • Dry everything and test the supply and waste separately
  • Waste leaks appear only when water drains
  • Hand-tighten plastic fittings and never use tools on them
  • Do not hide a leak with tape; the cupboard base will swell

Empty the cupboard and dry everything

Clear the cupboard, put a towel or tray down and dry every pipe and fitting with kitchen roll. Then test in stages. Leave the taps off for a while and check for drips; if any appear, the leak is on the supply side. Next, run the hot tap, then the cold, then fill the sink and pull the plug, checking after each.

A dry tissue wrapped around each joint shows exactly where water forms. Water runs downhill along pipes, so the wettest point is not always the source.

Waste and trap leaks

If the leak appears only when water drains, it is on the waste side. Plastic traps and waste pipes use push-fit or compression joints with rubber washers. These can work loose, or the washer can be pinched or perished. Hand-tightening the large plastic nuts often stops a weep, but do not use tools on plastic as it cracks.

A leak at the sink outlet itself, where the waste meets the bowl, usually means the seal under the outlet has failed. That needs the waste removing and reseating. Our drain trap types guide explains the different traps you may find.

Supply pipe and tap connection leaks

Constant drips with the taps off come from the supply. Most modern taps connect with flexible hoses screwed into isolation valves or compression fittings. A drip at a compression nut can sometimes be cured with a careful quarter turn, holding the fitting body still with a second spanner so the pipe does not twist.

Flexible hoses can perish or kink over time, and a swollen or rusty braid is a sign to replace them before they fail. A leak from the isolation valve spindle usually means a new valve.

Leaks from the tap or appliance

Sometimes the water under the sink comes from above. A tap leaking at its base drips down behind the sink and appears in the cupboard. Washing machines and dishwashers that share the sink waste can leak from their own hoses or connections, often only during a cycle.

If the tap itself is the problem, our tap repair and replacement page explains the options. Appliance connections are covered by our washing machine and dishwasher plumbing service.

What not to do

Do not wrap a leaking joint in tape and close the cupboard door. Tape rarely holds on a wet pipe and hides the problem while the cupboard base swells. Avoid overtightening compression fittings, which can distort the olive and make the leak worse.

If a supply pipe leak is heavy, turn the water off at the isolation valve under the sink if there is one, or at the main stopcock.

When to call a plumber

Call a plumber if the leak is on a soldered joint, a corroded pipe, the sink outlet seal or anywhere you cannot reach safely. Also call if the cupboard base or the floor beneath has been wet for a while, as damage may need checking.

Our common plumbing repairs page covers other kitchen and bathroom faults, and our plumbing service quotes these jobs before any work starts.

Want a professional to handle it?

See your fixed price in 24 hours

Calls answered 8am-6pm Mon-Fri · missed calls returned the same day.

"A master of his class, gone above & beyond to deliver exactly what I wanted, to an extremely high spec.", Jamie, verified review

We cover Gloucester, Cheltenham, Tewkesbury, Stroud, Stonehouse, Malvern, Ledbury, Newent and Ross-on-Wye, plus the surrounding villages.

No spam · Reply within 2 hours on working days · Free, no-obligation quote

Local & Reliable
Free Quotes
Quality Workmanship
Bathroom & Plumbing Specialists

Quick questions

How do I tell if the leak is from the waste or the supply?

A waste leak only drips while water drains. A supply leak drips constantly, even with the taps turned off.

Can I tighten a leaking trap myself?

Often yes. Hand-tighten the plastic nuts first. Do not use tools on plastic fittings, as they crack easily.

Why is my sink leaking only when the dishwasher runs?

The dishwasher hose or its connection to the sink waste is the likely source, rather than the sink pipework itself.

How long does fixing a leaking pipe under a sink take?

Reseating a trap or replacing a hose is usually a short job. Remaking a sink outlet or replacing corroded pipe takes longer.

Need a real quote, not just a guide?

We provide free, written, itemised quotes for plumber across Gloucester, Cheltenham, Tewkesbury, Stroud and Newent.

Need it fixed rather than diagnosed? Book a leak or drain repair

Related services

Covering Gloucester, Cheltenham, Tewkesbury, Stroud, Malvern, Ledbury, Newent and Ross-on-Wye