The most common places
In most houses the stopcock is under the kitchen sink, because that is often where the mains pipe enters. If it is not there, check under the stairs, in a downstairs cloakroom or toilet, near the front door, in a utility room or garage, or in a cupboard on an outside wall. In older homes it can be under floorboards near the front of the house, sometimes with a small hatch.
Follow the cold pipe feeding the kitchen tap downwards. The point where it comes up through the floor or wall is usually where the stopcock sits.
Flats and newer homes
In flats, the stopcock may be inside the flat, often in the kitchen, airing cupboard or bathroom, or in a shared riser cupboard on the landing. It is worth asking the building manager if you cannot find it, as some blocks have one valve per flat in a communal area.
Newer homes sometimes have the stopcock in an airing cupboard, near the boiler or behind a removable panel. Some new builds use a lever valve rather than a round handle.
How to recognise it
A traditional stopcock is a brass valve with a round or crutch-shaped handle on the incoming pipe, often with an arrow showing the direction of flow. Lever valves are a quarter-turn handle; when the lever is in line with the pipe the water is on, and across the pipe it is off.
Do not confuse it with small isolation valves under sinks and toilets, which only control one fitting. The stopcock is usually the first valve on the pipe after it enters the house.
Turning it off safely
Turn a round-handle stopcock clockwise to close it. Use steady hand pressure; do not use a wrench on a stiff handle, as it can snap the spindle or crack the body. Once it is closed, open a cold tap to check the water stops and to drain the pipes.
If a pipe has burst, our how to stop a burst pipe guide explains what to do next, including switching off any electrics near the water if it is safe to do so.
If it will not turn or does not stop the water
Stopcocks that have not been used for years often seize. A little gentle back-and-forth movement may free it. If it still will not move, or turns but water keeps flowing, the valve is worn and should be replaced.
There is also usually an outside stop tap, belonging to the water company, under a small cover in the pavement or at the edge of the property. It needs a special key and may be hard to reach. A working inside stopcock is far easier, which is why our stopcock replacement service renews valves that no longer do their job.
Simple habits that help
Once you have found it, tell everyone in the house where it is, and keep the area in front of it clear. Turn it a little once or twice a year to stop it seizing. A label on the cupboard door saves time for visitors and anyone looking after the house.
If you cannot find your stopcock at all, a plumber can trace the incoming supply. Our plumbing service can locate and, if needed, replace it during a weekday visit.