What a trap does
A trap is a bend or chamber that stays full of water after the fitting drains. That water seal stops drain gases from coming up through the plughole. The depth of the seal matters: too shallow and it can be pulled out by water rushing down another pipe, or simply evaporate in a rarely used room.
When a trap loses its seal, the first sign is usually a drain smell. Gurgling after the bath or a toilet empties is another clue that seals are being disturbed.
P traps
A P trap has a U-shaped bend with the outlet going horizontally into the wall. It is the most common type under basins and sinks where the waste pipe exits through the wall behind. P traps are simple, hold a good seal and are easy to clean by unscrewing the bend.
They suit most situations where the waste runs out through a wall at roughly the height of the trap.
S traps
An S trap has a similar bend but the outlet turns down vertically, typically into a pipe going through the floor. S traps are found in older properties and where the waste runs downwards. They are more prone to losing their seal, because water flowing down the vertical pipe can siphon the trap empty.
Where an S trap causes smells or gurgling, an anti-siphon version or a change to the pipe route can help.
Bottle traps
A bottle trap is a compact cylinder with the water seal inside. It looks neater under a pedestal or open-fronted vanity basin and takes up less space than a P trap. Bottle traps are easy to empty by unscrewing the base, which makes clearing hair and debris straightforward.
They are not ideal for kitchen sinks, where food waste and grease clog the small chamber. Chrome bottle traps are common on wall-hung basins where the trap is on show.
Bath and shower traps
Baths and shower trays have low-profile traps because there is little space under them. These have a shallower seal and are more likely to be affected by hair and soap build-up. Many shower traps have a removable cover and insert so they can be cleaned from above.
Wet rooms use a floor gully or linear drain with a built-in trap. Waterless and self-sealing valve traps are another option where space or seal loss is a problem. Our slow draining shower guide covers clearing them.
Keeping traps working
Run water in rarely used basins and showers every week or two to top up the seal. Clear hair from bath and shower traps regularly. In kitchens, avoid pouring fat down the sink and keep a strainer in the plughole.
If a trap leaks, check the washers and nuts first; our leaking pipe under sink guide explains how. For a smell, gurgling or slow drains that do not clear, our plumbing service can check traps, waste routes and venting on a weekday visit.