Into the pan or onto the floor?
Start by deciding which kind of leak you have. A leak into the pan shows as a constant trickle down the back of the bowl, ripples in the pan water or a cistern that tops itself up every so often without being flushed. This wastes water but does not damage the floor.
A leak onto the floor is more urgent, because water soaks into boards and joists. If the water is around the pan rather than below the cistern, it may be the pan connector or seal, which our toilet leaking from base guide covers.
Leaking into the pan
On push-button toilets, the drop valve has a rubber seal at the bottom. Scale, grit and age stop it sealing, so water seeps into the pan. Cleaning the seat of the valve and fitting a new seal usually cures it. Lever toilets with a siphon rarely leak this way unless the siphon itself has cracked.
A simple test is a few drops of food colouring in the cistern. Do not flush; wait half an hour. Colour in the pan confirms the cistern is leaking through.
Drips from under the cistern
Close-coupled toilets have a large rubber doughnut washer between the cistern and the pan, plus two or more bolts holding them together. Each bolt has its own washer. If drips form under the back of the cistern, one of these is the likely source. Tightening loose bolts gently can help, but overtightening cracks ceramic.
Worn washers need the cistern draining, the bolts removing and new seals fitting. This is a common and straightforward repair once the right kit for the toilet is found.
Leaks at the supply connection
Water dripping from where the supply pipe enters the cistern points to the fill valve connection, the isolation valve or the flexible connector. Wipe everything dry and watch with a tissue to find exactly where it forms. A loose nut is easy; a cracked fitting or perished connector needs replacing.
If the water comes from a pipe going out through the wall instead, the cistern is overflowing. That is a fill valve problem, explained in our overflow pipe dripping guide.
Condensation or a cracked cistern
Beads of water all over the outside of a cistern, especially in cold weather or after a shower, are usually condensation rather than a leak. Better ventilation helps. A hairline crack in the ceramic, by contrast, leaks steadily from one point and cannot be reliably repaired; the cistern, or the whole toilet, needs replacing.
If you are not sure, dry the cistern completely and dust it with a little talc. A leak shows as a single wet track.
When to get help
Turn off the isolation valve and dry the floor if water is escaping, then arrange a repair. Call a plumber if the leak is between cistern and pan, the toilet is a concealed or wall-hung type, or you cannot identify the parts.
Our toilet repair service covers cistern leaks, seals and valves, and our plumbing service can look at any other fixtures on the same visit.