Lift the lid and look first
Take the cistern lid off carefully and put it somewhere safe, as it is heavy and breaks easily. Check the water level. If the cistern is empty or very low, the problem is with filling rather than flushing. If it is full, press the handle or button and watch what happens inside.
You are looking for a mechanism that moves but does not lift, a chain or rod that has come loose, or a button that pushes down without connecting to anything. Most no-flush faults become obvious within a minute of watching.
Handle and lever toilets
Older toilets with a side handle use a lever arm inside the cistern connected to a siphon. If the handle feels loose and floppy, the link between the lever and the siphon has usually snapped or slipped off. A replacement link or lever is a small part.
If the handle is firm but the flush is weak, the siphon diaphragm, a flexible plastic washer, may be split. Water then leaks past it instead of being lifted. Replacing the diaphragm usually restores a full flush, although on older siphons replacing the whole siphon is often simpler.
Push-button toilets
Push-button cisterns use a drop valve that lifts when the button is pressed. If the button feels loose, the cable or rods connecting it to the valve may have come apart, or the button itself may have cracked. Dual-flush buttons have two linkages, so it is common for one half to work and the other not.
If the button connects but the valve does not lift far enough, the flush will be weak. Some valves have adjustable rods or a height setting. Limescale can also make the mechanism stick, particularly in hard water areas.
When the cistern is not filling
If the cistern is empty or fills very slowly, check the isolation valve on the supply pipe, usually a small screw valve near the cistern. It should be fully open. If it is open, the fill valve may be blocked with scale or debris, or have failed altogether.
A fill valve that will not shut properly is a different fault, covered in our toilet keeps running guide. A cistern that is leaking water out rather than filling up is covered in our leaking toilet cistern guide.
When the pan, not the cistern, is the issue
If the cistern empties properly but the pan fills and clears slowly, the problem is more likely a partial blockage in the pan or waste pipe. Stop flushing to avoid an overflow and use a plunger designed for toilets.
If several fittings drain slowly or the toilet gurgles when the bath empties, the blockage is further down the drain. Our blocked drain guide explains the signs.
When to call for toilet flush repair
Call a plumber if the mechanism needs replacing and you are not confident working inside the cistern, if the cistern is a concealed type behind a wall panel, or if parts for your model are hard to identify. Concealed cisterns need access through the flush plate or panel and the right parts for the frame.
Our toilet repair page covers the faults we fix, from flush mechanisms to fill valves and leaks, Monday to Friday.