Which overflow is it?
Look at where the pipe comes out. A small plastic pipe at ground or first-floor level, usually close to the bathroom or cloakroom, normally serves a toilet cistern. A pipe high up under the eaves often serves a cold water storage tank in the loft. Some homes also have a feed and expansion tank for an older heating system with its own overflow.
Follow the pipe back inside if you can. If more than one toilet shares an outside wall, check each cistern in turn.
Toilet cistern overflows
Many modern cisterns overflow internally into the pan rather than outside, so you may see water trickling down the bowl instead of dripping outside. Older cisterns have an external overflow. In both cases the cause is the fill valve not shutting off at the correct level.
Lift the cistern lid and look at the water level against the overflow pipe or the marked line. If water is running into the overflow, the fill valve needs adjusting, cleaning or replacing. Our toilet keeps running guide covers that fault inside the cistern in more detail.
Loft cold water tank overflows
Homes with a cold water tank in the loft have a float valve, a ball on an arm or a modern equivalent, that shuts off the mains supply when the tank is full. If the washer is worn, the arm is bent or the float is damaged, the tank keeps filling and the excess runs to the outside overflow.
Working in a loft needs safe boarding and good light. The tank lid should be in place, and any insulation around the tank and pipes should be put back afterwards.
Adjusting the fill level
Most fill valves can be adjusted so they shut off lower. On modern toilet valves this is a screw or a clip on the float; on older ball valves the arm can be adjusted. Setting the level a little below the overflow gives a margin.
If adjusting the level does not stop the drip, the valve seal is probably worn or blocked with scale. Replacing the valve is usually more reliable than repeatedly cleaning an old one. Hard water shortens their life.
Why not to ignore it
A constant overflow wastes water, which matters if the home has a water meter. Outside, a running overflow can stain walls, make paths slippery and, in a freeze, form ice. In some cases a frozen overflow can stop working altogether, which removes the safety outlet for the tank or cistern.
A cistern that overflows inside into the pan is quieter but wastes water in the same way. Our leaking toilet cistern guide explains how to tell an overflow from a leaking flush valve.
When to call a plumber
Call a plumber if you cannot identify which fitting is overflowing, if the tank is in a loft you cannot reach safely, or if the valve needs replacing and you are not confident isolating the supply. Overflows connected to heating tanks are best checked by someone familiar with the system.
Our toilet repair page covers fill valves and cistern faults, and our plumbing service covers other fittings in the house during a weekday visit.