Who half height screens are for
Half height screens are mainly used where someone needs help showering. The carer stands outside, reaches over the doors and helps with washing and rinsing while staying mostly dry. The person showering can sit on a shower seat or stand with support, and the doors fold back to make getting in and out easier.
They also suit households planning ahead, where a full-height enclosure would get in the way of a future carer. For a fully independent user, a standard full-height screen usually contains water better.
How half height shower doors work
Most designs use two hinged doors that open outwards and fold flat against the wall, leaving the whole entrance clear. Some use a single hinged panel or a combination of fixed and folding sections. The doors often have a rising hinge so they lift slightly as they open, clearing the floor, and drop back to seal when closed.
The bottom seal is important. On a level-access floor, the doors need a seal that sweeps the floor without catching. On a tray, the doors sit on the tray edge.
Spray, splash and positioning
Because the top is open, some spray will escape, particularly from a handset raised high. Positioning the shower head and controls lower and towards the back wall helps. A handheld shower on a riser rail lets the carer direct the water down rather than outwards.
The floor outside the screen should be slip-resistant and, on a level-access shower, laid with enough fall towards the drain. Our level access shower page explains the floor side of the job.
Space and access
Folding doors need clear wall space on each side to fold back fully. Measure the width of the entrance and the wall space beside it before choosing a model. If a wheelchair or shower chair will be used, check the opening width and the turning space outside the shower.
Grab rails and a shower seat should be planned alongside the screen so the doors do not clash with them when folded. Rails need fixing into solid backing, not just tiles.
Fitting a half height screen
Fitting involves fixing the wall profiles or hinges to a solid wall, setting the doors level, adjusting the hinges and fitting the bottom seals. On an existing shower, the tray or floor must be level and the wall sound enough to take the fixings. Old fixing holes from a previous screen may need filling.
If you are replacing a full-height door with a half height one, or swapping a worn screen, our shower door replacement service covers removing the old one and fitting the new doors.
Alternatives to consider
A shower curtain on a ceiling or wall track is cheaper and fully flexible, but less tidy and harder to keep clean. A full wet room with a fixed panel offers open access but more spray. Where help is only needed occasionally, a wide full-height door with a large opening may be enough.
For wider changes, such as replacing a bath with a level-access shower, see our accessible bathroom service.